Collectionneurs de Flippers
vous connecter

Collection de flippers de cspiby
2 flippers
mis à jour le: 17/02/2016
  Collectionneur: cspiby
Localisation: Kendal, United Kingdom (trouver sur la carte)
Spécialités': Flippers à afficheur Dot matrix
Inscrit le: 10/01/2014
0 membres aiment

cspiby possède ces 2 flippers:

nom du flipperDBfabricantÉtatà vendre?notesphotos
THE SOPRANOS Stern (USA)Monté, jouableJamais
WORLD CUP SOCCER Midway (USA)Monté, jouableJamais
 
 
Flippers que cspiby possédait dans les années passées
(les flippers suivants ne sont plus dans la Collection de cspiby)
 
 
nom du flipperDBfabricantà vendre?notesphotos
HOOK Data East (USA)Vendu 
JOHNNY MNEMONIC Williams (USA)Vendu 
LETHAL WEAPON 3 Data East (USA)Vendu 
ROLLERCOASTER TYCOON Stern (USA)Vendu 
THE SHADOW Midway (USA)Vendu I have completely stripped the playfield, everything has been cleaned, playfield has been waxed at least 3 times after being thoroughly cleaned. repaired the sanctum area with acrylic paint, applied a water slide and finally mylar'd over the top, the match isn't perfect but better than the bumpy smudgy mess that was there before. It has also been re-rubbered, all the inserts are LED, the GI are incandescent as a personal preference on this machine but I have installed 2 spotlights on the slings to attempt to throw more light into the middle of the playfield. The stand-ups on the N and G targets of MONGOL were some weird red and green things that looked home-made, these were replaced with the correct yellow ones. Mechanically it's very good, everything works as it should, with the sanctum now being flat, the magnet works really well, I have swapped 95% of the coil sleeves with new ones, the cabinet has been vacuum'd out. The playfield was removed entirely for the sanctum repair but I've routed all the wires in the backbox exactly as they should be from the factory. The cabinet artwork is very good, only let down by the decals on the head, the DMD requires a small amount of warm-up but works fine, no lines out. Unfortunately someone saw fit to put a screw through the mini playfield (lower left), it was like that when I got it, but I've now removed it, fortunately its not in a traffic area so it shouldn't matter too much. The left ramp has been welded at some point but its kind of expected with way the diverters slam into the sides on this. There are a couple of missing plastics around the VUK and the one under the left diverter is broken in two but isn't obvious unless you're looking for it. The screws secure both pieces just fine. The top bolt holes on the back leg plates are threaded, so you have to use bolts on the inside, not really a problem, easy enough to change but just never felt the need as bolts do the job just fine. £1600 ono
IMPORTANT: Cette page montre la collection de flippers du membre cspiby de Kendal, United Kingdom. Les flippers à monnayeur énumérés ci-dessus, y compris leurs images, ont été téléchargés dans notre base de données par cspiby lui-même; cspiby est le seul responsable de l'information contenue en cette page. Les flippers montrés ci-dessus ne sont pas nécessairement à vendre! Veuillez se référer à la 4ème colonne dans la liste pour savoir si un certain flipper est en vente ou pas. Très probablement, la plupart des flippers de cspiby sont des flippers d'occasion qui ont été installés dans les cafes et d'autres lieux publics; leur valeur en tant que collectable dépend en grande partie de l'aspect et de la fonctionnalité de chaque flipper.
 
 
Commentaires par d'autres membres de notre communauté

Pas encore de commentaires.
 
 
 
 
Suggestions? Problèmes? Contactez l'Administrateur!
l'utilisation de ce site implique votre acceptation de notre Code de Conduite